4
9. Torque the stock forward muffler chassis mount
bolt to factory specification.
10. Torque (No. 8)
03019143,
exhaust clamp to
8.5 Nm (0.86 kg-m, 6 ft-lb).
11. Clean number plate thoroughly with soap and
water where heatshield foil will be applied.
12. Remove adhesive backing from foil heatshield
and apply onto the inside of the number plate.
Note: Be sure number plate is dry and clean
prior to applying heatshield foil. Debris
may hinder the foil from adhering to the
surface.
13. Re-install right side panel.
14. Before starting motorcycle, check for proper
clearance between new exhaust system and
rear suspension (i.e. tire, swing arm, brakes,
rear shock, and etc.) If any problem is found,
please carefully follow through the installation
steps again. If problem still persists, please call
Yoshimura Tech Department at (800) 634-9166
/ in CA (909) 628-4722.
15. It is recommended that the muffler and tailpipe
be wiped down with rubbing alcohol to remove
oil and fingerprints. This will help prevent
tarnishing of the finish after the exhaust is
heated up.
Note: After starting motorcycle, it is normal for
new exhaust system and muffler to emit
smoke until oil residue burns off.
