1. Remove rider seat.
2. Remove the rear tail cover.
3. Locate and disconnect the license plate light
and turn signal connectors.
4. While securely supporting the stock fender
assembly, remove the four bolts securing the
fender assembly to the frame. Carefully remove
the stock fender assembly making sure not to
damage the connectors in the process.
Note: The lower “U” shape fender bracket will
be re-used when installing the Yoshimura
fender eliminator.
5. Disassemble the stock fender assembly and
remove the left and right turn signals.
1
Note : The stock turn signal hardware will be
re-used when re-installing onto
Yoshimura turn signal brackets.
2
Note : The stock tail light / upper fender shroud
will not be re-used.
6. Cut the stock license plate light connector from
the stock fender assembly. Be sure to cut at
least a 6” section of wire from the connector.
Removal
Installation
1. Install (No. 2)
070BG-LH-K1,
Yoshimura license
plate light onto (No. 1)
14950-FEBKT,
Yoshimura fender eliminator bracket
using
(No. 6)
M4X6BHS,
4mm button head screws
provided in the kit.
2. Using the stock hardware, install left and right
turn signals onto (No. 4,5)
14200-TSL/R,
left and right turn signal brackets.
3. Assemble and install (No. 3)
070BG-LPF,
license plate frame and (No. 4,5)
14200-TSL/R,
turn signal brackets to (No. 1)
14950-FEBKT,
fender eliminator bracket using the hardware
supplied in the kit as shown.
4. Route license plate light and turn signal wires
through the hole in bracket and under the seat.
Secure assembled fender eliminator kit to frame
using the stock fender bolts and the stock lower
“U” shape fender bracket. Torque to factory
specification.
1
Note : If the side reflector bracket plate is to be
re-used, the (No. 11)
14950-FESPCR,
fender eliminator spacer is not required.
2
Note : If the side reflector bracket will not be
used, install (No. 11)
14950-FESPCR,
fender eliminator spacer between the
frame and (No. 1)
14950-FEBKT,
fender
bracket as shown.
5. Because both of the stock license plate light
wires are black, determine the positive and
negative wires by re-connecting the license
plate light connector. Using the
BN-SSS-22-18
butt connectors provided in the kit, connect the
Yoshimura license plate light wires to the stock
license plate light wires as follows:
Brown/Yellow -to- Red
Black/Yellow -to- Black
3
8
5
7
4
9
10
2
1
6
1
3
11
