1. Remove passenger seat.
2. Disconnect the license plate light and turn signal
wires.
3. While securely supporting the stock fender
assembly, remove the three bolts and carefully
remove the stock fender assembly.
4. Disassemble the stock fender assembly and
remove left and right turn signals.
5. Cut the stock license plate light connector from
the stock fender assembly. Be sure to cut at
least a 6” section of wire from the connector.
Removal
Installation
1. Install (No. 4)
070BG-LH-K1,
Yoshimura license
plate light onto (No. 3)
12200-FEBKT,
Yoshimura
license plate bracket
using (No. 12)
M4X6BHS,
4mm button head screws provided in the kit.
3
4
12
3. Install (No. 3)
12200-FEBKT,
Yoshimura license
plate bracket onto (No. 2)
12650-FEBKT2,
fender eliminator bracket using (No. 11)
M6X10BHS,
6mm screws as shown below.
3
2. Assemble (No. 1)
12650-FEBKT1,
fender
eliminator bracket 1 to (No. 2)
12650-FEBKT2,
fender eliminator bracket 2 as shown below.
Note: Use (No. 8)
M6X22BHS,
6mm screw to
align all holes when installing (No. 11)
M6X10BHS,
6mm screws.
1
11
2
8
11
3
2
4. Using the
BN-SSS-22-18,
butt connectors
provided in the kit, connect Yoshimura license
plate light wires to the stock license plate light
wires as follows:
Red -to- Brown
Black -to- Green
a) Strip the stock fender light wire ends
1/4” - 1/2” and insert into
BN-SSS-22-18,
butt connectors provided in the kit.
b) Center the spliced wire ends in the
middle and using a heatgun or lighter,
apply heat evenly on the outer edges of
the butt connector to shrink and hold
wires in place.
c) Making sure that the stripped ends are
centered, heat the center of the butt
connector evenly until the solder begins
to liquify.
d) Allow to cool completely and tug both
ends of the wires to verify that connection
is secured.
Scan for link to butt connector instruction video.
5. Install the stock left and right turn signals onto
(No. 6,7)
12650-TSB-L/R,
turn signal brackets.
