2
YXL SERIES
1. Power Switch and Mode LED
The AC power switch on the rear panel turns
the power On or Off. The Mode LED turns on to
indicate power is supplied to the unit.
2. Mode Switch
The Mode Selector applies specific EQ and
tone settings for the YXL Series powered
enclosure, effectively custom tailoring the
speaker for any environment.
Concert:
Allows instruments and vocals to
be equally and naturally reproduced which
is best for live performance.
Club:
Boosted bass and enhanced highs
make this mode ideal for music playback.
Monitor:
Optimized for use as a stage
monitor and the human voice while
minimizing feedback.
3. Master Control
The Master control sets the level of ALL sound
coming out of the YXL Series enclosure. If there
are multiple YXL Series speakers in a system,
the volume of each speaker is individually set by
using each enclosure’s Master control.
4. Activity LED
This LED illuminates when audio signal is present from all sources being sent to the Master.
NOTE: If the Master is turned to Min, the Activity LED will not illuminate.
5. Bluetooth®
The Yorkville YXL Series is capable of receiving streaming audio over Bluetooth® from devices
such as smart phones, tablets and laptops. Pairing your device with the YXL Series is simple and
gives you the freedom to play your music wirelessly.
6. Bluetooth® Pairing
To pair your Bluetooth® device, depress the Bluetooth® switch for approximately 4-seconds. The
blue LED will flash to indicate the YXL speaker is ready to be paired.
7. Linking Multiple Cabinets Using Bluetooth®.
Bluetooth® can be used along with the Link feature only when the first cabinet in the Link chain is
paired and the mixer is enabled. Pair with the first cabinet using Bluetooth® and leave the others
unpaired. Then, use the appropriate XLR cables to Link between the multiple cabinets by wire
through the Link/left channel connection. If Stereo Bluetooth
®
is desired, set the “paired” cabinet
to Stereo Mode, the right channel will play on the paired cabinet and the Left signal will play on the
cabinet connected to the L/Link jack.
8. Onboard Mixer and Mixer Enable Switch
The Mixer Enable switch turns the onboard mixer ‘on’ or ‘off.’ When the Mic or Line inputs are
used, this switch must be set to the ‘on’ position. If these inputs are not being used, the mixer
should be turned ‘off,’ this will help prevent the mixer from contributing noise to the system.
The onboard mixer should not be used when a source other than another YXL Series powered
speaker (or similar) is connected to the LINK jack. Remember, a maximum of 3 mixers, in a
chain of enclosures, should be used! A much larger number of enclosures may be used with
the mixers disabled on the additional enclosures.
Clip
Activity
MASTER
1
Clip
2
Clip
3
Aux In
Instrument
Line
Mic
Pairing: Hold
for 4 sec,
then release
Mixer Enable
100 Hz
LINK
MAIN In
Sub
IN
OUT
IN
OUT
Mode
Stereo/Mono
Concert
Club
Monitor
Min
Max
Min
Max
Min
Max
Min
Max
Mic
90 Hz
