2
YX SERIES
3. Link Jacks
The Link jacks are directly connected to the input jacks, use these jacks to send your source signal
on to additional YX10SP subs.
4. High Pass Output Jacks
High Pass output jacks are provided to eliminate the need for an external crossover. Use
these jacks to feed the input of your full-range loudspeakers. The signal from these XLR jacks
has had the audio below 80 Hz rolled-off, allowing for a flat system response when feeding
the full-range loudspeakers.
5. Ground Lift Switch
In normal operation, keep the Ground Lift switch in the depressed position. If an audible hum is
present in your system, try “lifting” the ground to break a ground loop in your system.
6. Protection and Indicators
The YX10SP has circuitry to prevent clipping, over-current and over-excursion. At high power levels
the internal limiter will limit the gain of the YX10SP. The level control should be set while operating
at low levels (under 10 watts). If the level control is set too high, the input circuit will clip and the
dynamics of the bass will be lost. If the user tries to set the subwoofer level control at a high level,
the resulting setting will be incorrect.
In normal operation, the rear LED indicator will flash green when a signal is present. When the
indicator starts flashing red, the limiter is engaging. Increasing the input signal beyond this point
will potentially result in undesirable audible clipping.
AT HIGH POWER LEVELS WHEN THE LIMITER IS OPERATING INCREASING THE SUBWOOFER
LEVEL CONTROL WILL NOT INCREASE THE OUTPUT. DO NOT INCREASE SETTING WHILE
OPERATING AT HIGH LEVELS.
Summary of Contents for YX10SP
Page 9: ...7 YX SERIES...
