7
■
The Indoor Unit
To make sure
●
There is enough room for installation and maintenance (Refer to Fig.1 and Fig.2 ).
● The ceiling is horizontal, and its structure can endure the weight of the indoor unit.
● The air outlet and the air inlet are not impeded, and the influence of external air is the least.
● The air flow can reach throughout the room.
●
The connecting pipe and drainpipe could be extracted out easily.
●
There is no direct radiation from heaters.
Model
H
YCK3F (10-18) AAS-W
150
YCK3F (20-60) AAS-W
108
■
The Outdoor Unit
To make sure
●
There is enough room for installation and maintenance.
●
The air outlet and the air inlet are not impeded, and can not be reached by strong wind.
●
The place is dry and ventilative.
● The support is flat and horizontal and can stand the weight of the outdoor unit. And no additional noise or
vibration.
●
Your neighborhood will not feel uncomfortable with the noise or expelled air.
●
There is no leakage of combustible gas.
●
It is easy to install the connecting pipe or cables.
● When 2 or more outdoor units are installed at the same zone, there must be adequate space between units for
avoiding short air cycle.
!
Cautions
Location in the following places may cause malfunction of the machine.
(If unavoidable, please consult your local dealer.)
a. There exists petrolatum.
b. There is salty air surrounding (near the coast).
c. There is caustic gas (the sulfide, for example) existing in the air (near a hot spring).
d. The bolt vibrates violently (in the factories).
e. In buses or cabinets.
f. In kitchen where it is full of oily gas.
g. There is strong electromagnetic wave existing.
h. There are inflammable materials or gas.
i. There is acid or alkaline liquid evaporating.
j Other special conditions.
■
Notes Before Installation
1. Select the correct carry-in path.
2. Move this unit as originally packaged as possible.
3. If the air conditioner is installed on a metal part of the building, it must be electrically insulated according
to the relevant standards to electrical appliances.
Installation Place
Fig. 1
Fig. 2
(unit: mm)
Installation space(unit: mm)
1500 Over
2500~3000
1500 Over
Air outlet
Air outlet
Air inlet
320
Overlap between ceiling and
ornament panel shall be 25mm
Ceiling
Suspending bolts
Ornament panel
H
30
