7HFKQLFDO,QIRUPDWLRQ
6HUYLFH0DQXDO
ƾ
●
●
●
●
●
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Reinstall the battery cover plate.
When replacing the batteries, do not use old or different types of batteries,
If the remote controller will not be used for a long time, please
otherwise, it may cause malfunction.
remove batteries to prevent batteries from leaking.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the remote controller does not operate normally, please take the
batteries out and reinsert them after 30 seconds.If it still can't operate properly,
Notes:
replace the batteries.
Sketch map for
replacing batteries
Replacement of Batteries
About Back-lighting Function
20
Press “TEMP” and “CLOCK” simultaneously in COOL
“SE”. Repeat the operation to quit the function.
mode to start energy-saving function.Nixie tube on the remote controller displays
Combination of " TEMP " and "CLOCK" buttons : About Energy-saving Function
18
Press “TEMP” and “CLOCK” simultaneously in HEAT mode to start
The unit lights for 4s when energizing for the first time, and 3s for later press.
8
℃
Heating Function
Nixie tube on the remote controller displays
(46 if
Fahrenheit is adopted). Repeat the operation to quit the function.
Combination of " TEMP " and "CLOCK" buttons : About 8
℃
Heating Function
19
̧
.
“ ” and a selected temperature of “ 8
℃
”
