
TIMER ON button can set the auto-on time of the
unit. TIMER OFF button can set the auto-off time
of the unit.
To set the starting time
1. Push the TIMER ON button, then the remote
controller shows TIMER ON, the last set time for
the starting operation and the signal “h” will be
shown on the LCD DISPLAY area. You are now
ready to reset the time to START the operation.
2. Push the TIMER ON button again to set desired
unit start time.
3. After setting the TIMER ON, there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the signal
“h” disappears and the set temperature will re-
appear on the digital display.
To set the stopping time
1. Push the TIMER OFF button and the remote
controller will show TIMER OFF, the last set time
for the stopping operation and the signal “h” will
be shown on the LCD DISPLAY area. You are now
ready to reset the time of the STOP operation.
2. Push the TIMER OFF button again to set the time
you want to stop the operation.
3. After setting the TIMER OFF, there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the signal
“h” disappears and the set temperature will re-
appear on the digital display.
Features of remote controller
MODE Select Button: Each time you push the button, a mode is selected
in a sequence that goes from AUTO, COOL, DRY, HEAT, and FAN, as the
following figure indicates:
NOTE:
#//,ONLYMODELHASNO(%!4FEATURE
FAN SPEED Button: This button is used for setting Fan Speed in the
sequence that goes from AUTO, LOW, MED to HIGH, then back to AUTO.
SWING Button: Push this button, the louver would swing up and down
automatically. Push again to stop it.
TIMER ON Button: Press this button to preset the time ON (start to operate).
Each press will increase the time ON setting in 30 minutes increments.
When the setting time displays 10:00, each press will increase the time ON
setting in 60 minutes increments. To cancel the time ON program, simply
adjust the time ON to 0:00.
LED DISPLAY Button: Press this button to clear the digital display in the air
conditioner, press it again to activate it (Not applicable to units without this
function).
RESET Button: When the RESET button is pushed, all of the current settings
are cancelled and the control will return to the initial settings. (Use a 1mm
little round stick to push the button)
TURBO Button: Push this button on COOL/HEAT mode, the air conditioner
goes into powerful cooling or heating operation. Push again to cancel the
TURBO function.
SLEEP Button: Press this button to go into the Energy-Saving operation mode.
Press it again to cancel.
ON/OFF Button: Push this button to start the unit operation.
Push the button again to stop the unit operation.
AIR DIRECTION Button:
Push this button, the louver can be fixed at a desired
angle. The louver swing (upward or downward) to a certain angle for each
press. When the louver swings at an angle which would affect the cooling
and heating efficiency of the air conditioner, it would automatically change
the swing direction (upward or downward).
TIMER OFF Button: Press this button to preset the time OFF (turn off the
operation). Each press will increase the time OFF setting in 30 minutes incre-
ments. When the setting time displays 10:00, each press will increase the
time OFF setting in 60 minutes increments. To cancel the time OFF program,
simply adjust the time OFF to 0:00
Timer operation
7
2
AUTO
COOL
DAY
HEAT
FAN
J265_EN.indd 4
12/7/05 3:43:28 PM