![background image](http://html1.mh-extra.com/html/york/dhp30nwb21sdcp30nwb21sdhp36nwb21sdcp36nwb21s/dhp30nwb21sdcp30nwb21sdhp36nwb21sdcp36nwb21s_service-manual_4165354035.webp)
28
Service Manual
3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In this case, will blink,After that,press Enter/Cancel
to make a confirmation.
Swing Off: When the Swing function is on, press Function to enter the Swing setting interface,with blinking. After that, press
Enter/Cancel to cancel this function. Swing setting is shown
below in
Fig.3.6.1.
Notes:
(1)Sleep, Turbo or Blow setting is the same as the Swing setting.
(2)After the setting has been done, press the key “Enter/Cancel” to
go
back to the setting status or quit automatically five seconds
later.
3.7 Sleep Setting
Sleep on: Press Function under the On state of the unit
until
the unit enters the Sleep setting state. After that, press Enter/Cancel
to confirm this setting.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting status. After that, press Enter/Cancel to cancel
this function.
In the Cooling or Dry mode, the temperature will increase by
1°F~2°F (
1°C) after the unit runs under Sleep1 for 1hr and
1°F~2°F
(
1°C) after another 1hr.
After that, the unit will run at this temperature.
In the Heating mode, the temperature will decrease by
1°F~2°F (
1°C) after the unit runs under Sleep 1 for 1hr and
1°F~2°F (
1°C) after
another 1hr.
After that, the unit will run at this temperature.
Timer range: 0.5-24hr. Every press of ▲or ▼ will make the set time increased or decreased by 0.5hr. If either of them is pressed
continuously, the set time will increase/ decrease by 0.5hr every 0.5s.
Fig. 3.6.1 Swing Setting
Summary of Contents for DHP30NWB21SDCP30NWB21SDHP36NWB21SDCP36NWB21S
Page 48: ...41 Compressor starts normally...
Page 88: ...81...