ROOM AIR CONDITIONERS
5
IOM # 036 - 3007 TP (0206)
FRESH AIR VENTILATION
This is usually kept in the
closed position and is used
only when smoke and / or
odors are required to be
cleared from the room. When
the ventilation lever is pushed
to ‘CLOSE’, the fresh air
ventilation is closed, when the
ventilation is pushed to
‘OPEN’, the fresh air
ventilation takes place.
Note: There is some difference
in the operation method
between different models. For
some models, when the
ventilation lever is pushed
forward, the fresh air
ventilation is closed, when it is
pulled outward, the fresh air
ventilation is opened.
Note : The VENTILATION LEVER should normally be
kept in the CLOSED position during cooling for
maximum cooling effect.
CLOSE
VENT
OPEN
MAINTENAINCE AND OPERATIONAL
CARE
Â
TO AVOID THE POSSIBILITY OF INJURY, BE SURE
TO DISCONNECT POWER SUPPLY TO THE UNIT
BEFORE SERVICING AND / OR CLEANING.
Do Not
use gasoline,
benzene, thinner or any other
chemicals, or insecticide to
clean the air conditioner, as
these substances may cause
flaking off of the paint, and
cracking or deformation of
plastic parts.
Never
attempt to clean the
unit by pouring water directly
over any of the surface areas,
as this will cause deterioration
of electrical components and
wiring insulation and it may
cause a short circuit or
electrocution.
CLEANING THE AIR FILTER
If the air filter becomes clogged with dust, air flow is
obstructed which reduces the cooling efficiency. The air filter
should be cleaned every two weeks.
!
CAUTION
1. Remove
Air
Filter (See
Installation Instructions,
Step 1, on Page 7).
2. Cleaning the Air Filter
Remove the dust clogged
in the filter by tapping it or
vacuum clean it. Wash
the filter well with lukewarm water or a neutral cleaning
agent.
3. Cleaning the Air Freshener
The air freshener is fixed
on the reverse side of the
air filter, and should be
cleaned together with the
air filter.
Rinse the filter and
fresher well using clean
water. Allow time to dry
completely.
4. Attaching the Air Filter
See Installation Instructions, Step 5, on Page 7.
Note
:
Never use hot water over 40°C (104°F) to clean
the air filter and air fresher. Never attempt to operate the
unit without the air filter.
CLEANING THE FRONT PANEL
During operation, dust may accumulate on the front panel,
use soft wet cloth with a neutral cleaning agent to wipe it.
Never use water over 50°C, alcohol, gasoline, acid, solvent
or brush to clean the front panel as this will damage the
surface.
END OF SEASON CARE
1. Operate the fan alone for half a day to dry out any
moisture from inside the
unit.
2. Turn off power and
remove plug from wall
outlet.
TROUBLE
SHOOTING
Problem : Unit is working, but cooling is not sufficient.
Possible Cause : It is quite
possible that the supply or
exhaust grill is blocked. This
prevents the unit from efficient
cooling. Remove any
obstructions.
Possible Cause : The outdoor
temperature may be
abnormally high due to the
unit being exposed to an
external source of heat.
