York Fitness T700, Owner'S Manual

Page: 18 / 23

Right and left Allen bolts are located at the rear of the treadmill.
Deck Lubrication:
The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board be
checked periodically for lubrication to ensure optimal treadmill performance.
Every 3 months of operation lift the sides of the walking belt and feel the top surface of the walking board as far
as you can reach. If you feel signs of silicone, no further lubrication is required. If it feels dry to the touch, follow
the instructions below.
Please use Lube ‘N Walk, which can be purchased from www.yorkfitness.com.au
TO APPLY LUBRICANT TO THE WALKING BELT
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the lubricant can.
3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board
approximately 6” from the front of the treadmill. Apply the silicone spray to the walking board, moving from
the front of the treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4
seconds on each side.
4. Allow the silicone to “set” for 1 minute before using the treadmill.
NOTE: When the treadmill is overload for safety reasons, the fuse will be broken
and the power will be cut off. Change a new fuse and start again.
www.yorkfitness.com.au
1
8