6 •
Inspiration Accomplish X-Trainer | INSTRUCTION MANUAL
ASSEMBLY INSTRUCTIONS
Getting Started
Place all parts from the box in a cleared area and position
them on the floor in front of you. Remove all packing
materials from your area and place them back into the box.
Do not dispose of the packing materials until assembly
is completed. Read each step carefully before beginning.
If you are missing a part, please contact our technical
support.
After unpacking the unit, open the hardware bag and make
sure that you have all the following items. Some hardware
may be already attached to the part:
Hardware Identification Chart
This chart is provided to help identity the hardware used
in the assembly process. Place the washers, the end of
the bolts, or screws on the circles to check for the correct
diameter. Use the small scale to check the length of the
bolts and screws.
NOTE: The length of all bolts and screws except those
with flat heads is
measured from below
the head to the end of
the bolt or screw. Flat
head bolts and screws
are measured from
the top of the head to
the end of the bolt or
screw.
Part No. 22 x 2
ALLEN HEAD BOLT (M8 X 78MM)
Part No. 23 x 2
ALLEN HEAD BOLT (M8 X 72MM)
Part No. 26 x 2
ALLEN HEAD BOLT (M8 X 20MM)
Part No. 27 x 10
ALLEN HEAD BOLT (M8 X 15MM)
Part No. 35 x 4
WASHER (M8 X Ø28MM X 1.5MM)
Part No. 37 x 12
WASHER (M8 X Ø16MM X 1.2MM)
Part No. 38 x 8
WASHER (M5 X Ø16MM X 1.2MM)
Part No. 39 x 18
M8 SPRING WASHER
Part No. 31 x 8
SCREW (M5 X 15MM)
Part No. 92 x 2
SCREW (M5 X 12MM)
Part No. 41 x 4
M8 CURVED WASHER
Part No. 30 x 2
SCREW (M8 X 25MM)
Part No. 49 x 2
M8 NYLOCK NUT
Part No. 67 x 2
PLASTIC CAP
AccomplishXTrainer_Manual.indd 6
1/15/09 5:48:14 PM
