3
1. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear.
2. Changes to opening and closing time can be done only in automatic mode.
3. Longer than 60 seconds pause between series of button clicks during programming will cause device to switch off
from time setting mode without saving any changes.
4. Group channel needs to chosen for transmitter to control all devices at the same time. That applies to all working
modes.
5. If while setting time of automatic opening or closing ‘--:--‘ symbol appears, it means that this time is not active in
automatic mode.
6. To leave time programming mode without saving any changes press STOP button.
7. To control receivers automatically from all channels set up a group channel
8. Group channel is active when all numbers are selected
The above steps need to be repeated for all five channels during the same programming.
By pressing the work mode
button, we set the automatic
or random mode.
By pressing ‘L1’ button
for approximately 3 seconds.
Opening time will appear.
Press L1 button.
Opening hour starts to flash.
Using UP and DOWN
buttons set hour.
Pressing L1 button switch
to minute settings.
Using UP and DOWN
buttons set minutes.
Pressing work mode button
switch to opening hour
settings.
Using UP and DOWN
buttons set minutes.
Using L1 button
buttons set minutes.
Using UP and DOWN
buttons set minutes.
6. Setting automatic opening and closing time
The above steps need to be
repeated for all opening and
closing hour in every day
of the week.
Pressing P1 configuration change
button confirm the set time
and go to set the hour
on the next day of the week.
After programming press and hold P1
button for about 3 second to confirm
all the changes. Set hour is flashing.
