2
1. Programming of a transmitter depends on the type of receiver. While programming you should abide by the manual of the
device, that the transmitter is supposed to control.
2. A break between succesive button presses longer than 6 seconds, will automatically cause the exit from programming
mode without saving the changes.
3. If limit positions have not been set, programming of the first transmitter will delete transmitters that were programmed
earlier.
5. Programming the first transmitter for motors of EV/S type
Turn on power supply or
press the programming
button on the cylinder head
(for 2 sec.) if the power
supply is on.
Motor will make a sound.
Blind will make short
up/down moves.
Press and hold STOP
button on the remote
control for 2 seconds.
Blind will make two short
up/down moves. Motor will
make a few short sound
signals.
1. Blockage of function keys prevents accidental pressing of two buttons used while programming motors or radio receivers.
2. This function is disabled due to factory settings. To turn it on/off you need to perform the following procedure.
1. Transmitter can operate in one of two modes:
a) bidirectional
b) unidirectional
2. The transmitter operates in bidirectional mode due to factory settings.
3. Blockage of function keys
4. Choosing the mode of transmitter operation
Take the battery out
of the transmitter.
Press P2
programming button.
If the LED diode lights up for 4 seconds,
the blockage function is on.
If the LED diode flashes a few times,
the blockage function is off.
If the LED diode flashes once and lights up steadily,
the transmitter operates in unidirectional mode.
If the LED diode flashes twice and lights up
steadily, the transmitter operates
in bidirectional mode.
Transmitter has been
programmed.
Put the battery in
while holding P2
programming button.
Press and hold
STOP button for 15 seconds.
OP
EN
-
CL
O
SE
M
P2
P2
OP
EN
-
CL
O
SE
M
P2
P2
OP
EN
-
CL
O
SE
M
P2
P2