3
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. If the end positions aren't set, the programming of the first transmitter will delete all existing transmitters from memory.
4. Choosing ‘0’ group channel means remote controls all programmed devices on all channels at the same time. No
programming functions can be performed on group channel. All devices programmed to any other channel can be controlled
on group channel without additional programming.
4. Programming first transmitter to EV/S-type motors
Turn on power supply
or press programming
button on motors head (for
2 sec.) when power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Press STOP button
for a 2 seconds
on the remote.
Roller shutter
will makean up/down
moveand the motor will
make a few short sounds.
