6. Programming first transmitter
7. Changing motors direction
8. Programming limit positions
4
1. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes
2.
If the limit positions have not been set, programming the first transmitter removes the previously programmed transmitters
from memory.
1. The limit positions are set automatically after the first cycle.
Press
UP button.
Press
DOWN button.
The motor will stop the curtain
and set the limit position.
The motor will
stop the curtain and
set the limit position.
The limit positions
have been set.
METHOD 1:
Changing the work motor direction using this method is only possible before the limit positions are programmed.
Press and hold
the programming button
on the motor for 2 seconds.
Simultaneously press and hold
UP and DOWN buttons
for 2 seconds.
LED diode will flash 5 times.
Motor will make few short
sounds.
LED diode flashed.
Motor will make a short sound.
Press and hold STOP button
for 2 seconds on the transmitter.
LED diode will flash 5 times.
Motor will make few sounds.
The transmitter
has been programmed.
The work motor direction
has been changed.
Work motor direction
has been changed.
METHOD 2:
Changing the direction of work motor with this method delete the limit positions.
Press and hold the programming
button on the motor for 6 seconds. Release
programming button after the second flash
of the diode. Motor will make 2 sounds.
Press
DOWN button.
LED diode will flash 5 times.
Motor will make a sound.
5
5
5
