Restoring the factory settings will delete the set automatic opening and closing times.
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming transmitter using this method will result in deleting receiver memory.
7. Checking and activating automatic opening and closing times
8. Factory settings
9. Programming first transmitter to R-type motors
4
Turn on power supply
or press microswitch
(for 2 sec.) when
power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will
make a sound.
Press P2
programming button.
or
Roller shutter
will make an
up/down move
and the motor
will make a few
short sounds.
Motor will
make a sound.
Press P2
programming button.
Press
UP button.
Use the WORK MODE
button to set the automatic
or random mode.
Use the WORK MODE
button to set the automatic
or random mode.
Press and hold P2
programming button for
about 15 seconds.
The factory settings have
been restored.
Press WORK MODE button.
Pressing the button again,
displays the programmed
times.
Simultaneously press the UP
and DOWN buttons to activate
or deactive an hour
in automatic mode.
To exit the mode
press STOP button.
P2
M
P2
P2
M
P2
P2
M
P2
P2
M
P2
P2
M
P2
P2
M
P2
