First Edition, September 2022
8
LFO
The LFO applies a modulating signal to the selected targets. The amount of the signal is traditionally controlled
using the modulation wheel on the built in virtual keyboard or an external MIDI keyboard. Further control
options are provided in the Prefs -> MODULATION panel.
WAVE: Specify the waveform of the modulating signal
RATE: Specify the speed of the modulating signal
TARGET SELECTORS: Select which synth parameters to modulate
TRK: Turn on key tracking. The signal will speed up the higher one plays on the keyboard.
RST: Turn on first-key-in phase reset for the signal
SYNC: Enable BPM syncing. When BPM syncing is turned on, the RATE knob can be used to specify the note
value at which the LFO will operate
MOD WHEEL: Specify the amount of modulation supplied to the selected target(s). Further settings for the Mod
Wheel and other modulation related controls can be found in PREFS -> MODULATION
Modulation Envelope
Use the ENV as an additional modulation source to obtain interesting sounds. The ENV amount can optionally
also be controlled via MIDI velocity and Mod Wheel. Options are located in PREFS -> MODULATION.
AMT: Peak value of the envelope at the end of the attack stage
S: Sustain value of the envelope at the sustain stage
A: Attack time
D: Decay time
R: Release time
TARGET SELECTORS: Select the synth parameters to modulate
