
< 3. Installation, Piping and Wiring >
3-1
IM 19H1D2-01E
3. Installation, Piping and Wiring
The submersion type holder comes in two configurations: one with a jet washing device and one
without. The submersion type holder with washing device is equipped with utility (air or water)
piping. To perform cleaning automatically at regular intervals, wires to operate the solenoid valve
in the utility piping have to be provided.
3.1
Installation procedure for the DO71 sensor
to DOX8HS
1. Pass GLAND from the cable side and place the bottom of the sensor on GLAND as shown
in the posture of the Figure 3.1.
2. Remove the protective cover put on the head of the sensor. Pass WASHER, GASKET,
WASHER, ADAPTER from the head of the sensor side.
Washer
Grand
Gasket
Sensor
body
Adapter
O ring
Be sure the distance between
the head of the sensor and the
end face of adapter is less
than 87 mm.
Protective
cover
Figure 3.1
Adapter Installation on the sensor
3. Keep the posture and screw ADAPTER to about on the surface of GLAND. The sensor is
positioned by screwing as shown in the posture of the Figure 3.1. The installation is correct
if the distance between the head of the sensor and the end face of ADAPTER is less than
87mm. By positioning the sensor, the measurement point can be the same even after
the reinstallation with maintenance works. Also, the installation position gets effective for
cleaning in the case of cleaning system specification.
Summary of Contents for DOX8HS
