25
Precision Making
Setup
16. Dual Capture
ScopeCorder introduction workbook
Copyright © Yokogawa Electric Corporation
Prerequisite:
In this exercise you will set up a ‘Dual Capture’. ‘Dual Capture’ is a feature which will record data at a low rate until a
trigger condition/event is detected after which data is recorded at high sample rate.
Disconnect the PROBE TIP from PROBE COMP; leave PROBE GROUND connected (important).
Follow these keystrokes:
Touch finger on/off PROBE TIP at 1 second intervals for 12
seconds, then press STOP. See next page for results.
1 sec/Div
DONE!
