3. Cabling
3-45
TI 33Q01J10-01E
RIO bus Cabling
IMPORTANT
The signal cable for the top IOU must be wired at the innermost part in the field control area as
the figure shows.
When fixing cables to a clamp, allow enough space so that the cards can be maintained.
Bind the bottom cables to the clamp bar on the channel base.
Push in the signal cables for the top IOU as far as they will go.
F030510.ai
Front
IOU
(1)
(2)
(3)
(4)
(5)
(1): Signal Cables for
the top IOU
(5): Signal Cables for
the Bottom IOU
Cable binding
bar
Figure Cabling
Connector Type IOU Cabling
How to connect cables of the lowest IOU
(connector type)
F030512.ai
60 mm
Fix to a clamp bar of
the channel base
After connecting dedicated cables to the connector type IOU,
extend them to the floor, push them to the bottom of the nest as far as they go,
and turn them to the left.
Bend the cables so as not to touch a door fan (See right).
When removing or inserting cards, make sure to bend cables as described herein.
Figure Connector Type IOU Cabling
May 18, 2007-00
