Rack Mounting
To rack-mount the instrument, use the separately sold rack mount kit.
Product Name
Model
AQ2211 rack mount kit (for mounting one AQ2211 to an EIA-standard rack)
735182-03
AQ2212 rack mount kit (for mounting one AQ2212 to an EIA-standard rack)
735182-09
An outline of the mounting procedure is given below. For detailed instructions, see the
manual that is included with the rack mount kit.
1.
Remove the handles from both sides of the instrument (from the left side of the
instrument in the case of an AQ2211).
2.
Remove the four feet from the bottom of the instrument.
3.
Remove the four seals the rack mount attachment holes on each side of the
instrument near the front.
4.
Place seals over the feet and handle attachment holes.
5.
Attach the rack mount kit to the instrument.
6.
Mount the instrument on a rack.
How to remove a handle cover
Note
• When rack-mounting the instrument, allow at least 10 cm of space around the inlet and
exhaust holes to prevent internal heating.
• Make sure to provide adequate support from the bottom of the instrument. The support
should not block the inlet and exhaust holes.
• Store the removed parts in a safe place.
• When rack-mounting the instrument, remove the feet from the rear of the instrument if they
are coming into contact with the rack and are thus preventing you from rack-mounting the
instrument. After you have rack-mounted the instrument, re-attach the feet to the rear of the
instrument. In this case, be sure to attach the brackets to the instrument before you remove
the feet from the rear of the instrument. If you don’t, the instrument’s cover may come loose
and fall when you rack-mount the instrument.
2.2 Installing the Instrument
2-5
IM 735101-01EN
Making Preparations for Measurements
1
2
3
4
5
Index
