2-19
IM 765501-01E
Explanation
of
Functions
3
2
1
6
5
4
9
8
7
12
11
10
15
14
13
18
17
16
Index
App
2.8
Store and Recall (Statistical Computation
Value Display)
Storage Operation
(See section 9.1 for the procedure)
This function stores up to 65535 points of the results of the source measure cycle in the
store memory. The contents of the store memory is output to the internal GS610RAM as
a result file (Result.csv) after the storage operation is complete. The contents output to
the result file are arrays of elapsed times from the store start point, source values,
measured values, and setting changes during the sweep operation.
When you press the STORE key, the storage operation starts and the STORE key
illuminates. Then, when the store count of source measure cycles is complete, the
storage operation automatically ends, and the result file (Result.csv) is created.
If you press the STORE key while the storage operation is in progress, the storage
operation is stopped, and the contents stored up to that point is saved to the result file
(Result.csv).
The store count can be set in the range of 1 to 65535.
Auto Storage
(See section 9.1 for the procedure)
The auto storage function automatically starts the storage operation with the start of the
sweep operation. The store count in this case is automatically set to the sweep repeat
count. However, if the sweep repeat count exceeds 65535, the store count is set to
65535.
Recall
(See section 9.2 for the procedure)
When you carry out a recall operation, the statistical computation results of the
measured values in the store memory can be retrieved. The statistical computation
parameters are the store count, minimum value, maximum value, maximum value –
minimum value, average value, and standard deviation.
