7
yodersmokers.com
Locate part B. Orient the part with the notched cutouts toward you. These cutouts will be labeled with a C
or a D sticker just inside the slot. These labels will match the Part ID of the leg that will be installed in that
cutout. FIG 4
Lay box 1 flat on the ground. Position part B cross-ways on top of box 1 as shown with the notched cut-
outs toward you. Orient part with the B decal facing down. Locate part C. Carefully slide part downward
through the indicated slot in part B until the holes align. FIG 5
Using a 5/16” nut driver or socket wrench, attach part C to part B with four A3 screws. Use caution to not
overtighten the screws! The screws are tight when the head of the screw is flush with the sheet metal.
FIG 6
Locate part D. Carefully slide part downward through the indicated slot in part B until the holes align. Using
a 5/16” nut driver or socket wrench, attach part D to part B with four A3 screws. Use caution to not over-
tighten the screws! The screws are tight when the head of the screw is flush with the sheet metal. FIG 7
Step #5
D
C
Parts Required:
Part B - Qty 1
Part C - Qty 1
Part D - Qty 1 Part A3 - Qty 8
FIG 4
FIG 5
FIG 6
FIG 7
