2
Pressing UP or DOWN button exits active channel selection mode. Repeat the following procedure to set the number of
active channels.
3. Active channel selection
Press simultaneously and hold down the C
and CHANNEL- buttons. "C" symbol appears on the
display and than after 4 seconds it changes
to number 15 with up and down arrows.
Use the C or CHANNEL - buttons
to set the number of displayed channels.
Press the STOP key to confirm your choice.
The symbol "o" should appear.
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 6 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. If the end positions aren't set, the programming of the first transmitter will delete all existing transmitters from memory.
4. Choosing ‘0’ group channel means remote controls all programmed devices on all channels at the same time. No
programming functions can be performed on group channel. All devices programmed to any other channel can be controlled
on group channel without additional programming.
6. Programming first transmitter to EV/S-type motors
Turn on power supply
or press programming
button on motors head (for
2 sec.) when power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Press STOP button
for a 2 seconds
on the remote.
Roller shutter
will makean up/down move
and the motor will
make a few short sounds.
1. The function buttons lock prevents accidental operation of two buttons used when programming motors or radio
receivers.
2. This function is factory disabled. To on / off the function, follow the procedure below.
1. The transmitter can operate in one of two modes:
a) two-way
b) one-way
2. The transmitter factory operates in two-way mode.
4. Function buttons lock
5. Selection of the transmitter's operating mode.
Remove the battery
from the transmitter.
Press programming
button P2.
When "L" symbol will appear on
the display the function is on.
When "U" symbol will appear on
the display the function is off.
When "1" number will appear on
the display transmitter is on
two-way mode.
When "2" number will appear on
the display transmitter is on
one-way mode.
When holding the P2
programming button,
insert the battery.
Press and hold STOP button
for about 15 seconds.
