YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
YMGI: Your Modern Green Idea
36
PIPING GUIDE
Set the packed pipes in a
vertical position and then
unwind them slowly.
Do not unwind only one end of
the coiled pipes.
Use pulley or a bending tool
to ensure a safe bending
radius.
Do not make any sharp or small
radius bends.
May also use rolling wheel to
reduce internal pipe tension
and avoid possible
deformation.
Do not bend long sections of
pipe without using bending
tools.
Use an elbow tool for
consistent bending radius.
Do not make bends that are
less than 90 degrees.
Maintain the minimum
bending radius.
Do not bend shot pipes.
PIPING AND WIRING SIZES-UNITS
Model
Liquid /
Gas Line
Min - Max
Length
+/-
Elevation
IDU
– ODU Wire
Power/ Control Wire Min.
Recommended HVAC
ODU Circuit Breaker/Fuse
09K
1/4" & 3/8"
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
20 Amp
12K
1/4" & 1/2
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
20 Amp
18K
1/4" & 1/2"
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
20 Amp
24K
1/4" & 5/8"
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
30 Amp
30K
1/4" & 5/8"
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
30 Amp
36K
1/4" & 5/8"
10 - 49.2
16.4
4 wire
L1/L2/G (
⏚
), 208-230/1/50 or 60
PV+/PV- 50-350 VDC
– AWG 8/10
30 Amp
The indoor unit and the outdoor unit can be at different heights either above or below each other. The height for the
difference must follow the stated requirements shown in the table below.
Keep bending of the piping line to a minimum to avoid negative impacts on the performance of the units.
Make a P-trap if the elevation drop difference is more than 24 inches, as illustrated below.
