YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
27
Heating operation:
The machine will overload if the air conditioner becomes too hot. The fan of the outdoor unit will stop automatically.
It is not a failure if the outdoor unit frosts when the fan stops.
Dehumidification operation:
The temperature is preset, and cannot be adjusted. The system will run at a temperature slightly lower than the
room’s ambient temperature. The fan will run at low speed and cannot be adjusted while in dehumidification mode.
Emergency Operation
If the remote controller is lost or broken, you can use the emergency operation switch found on the Indoor Unit.
When you push the button, emergency operation is selected.
Push once
Fan Direction and Fan Speed
To Change fan speed, push
FAN
button.
The indoor fan will change speed in the following sequence:
Automatic → HIGH → MED → LOW
Each time you push the button the unit will cycle to the next speed setting.
To change wind direction up and down push
SWING
button.
The swing blade will change the fan direction sequence time you push the button.
The Recommended Wind Direction of Up and Down
Normally use (Automatic Mode)
Set louvers to position 1 to 3 when in cooling or dehumidifying modes.
Set louvers to position 3 to 5 in heating mode.
Use the left-right guide louvers to
direct the fan’s air flow left or right.
When push the
SWING
button, the louvers will swing up and down.
Push the
SWING
button again, the swing mode will be cancel
SLEEP MODE
To set Sleep mode, make sure the unit is in Cooling or Heating mode.
Press the
SLEEP
button.
The “sleep” icon will appear on the control panel display.
