ASSEMBLY INSTRUCTIONS
8
VII. Password reset and record clearing:
1. The purpose of this function is to reset all passwords to their initial values and
clear all door access records. Please follow the steps below to perform the
operation.
2. First, disconnect the power supply and wait for the display to disappear,
indicating that the charge in the capacitors has been discharged. While
holding down the red button, press the power button to restore power.
3. After powering on, if the rear screen displays 'GOOD' (you can release the red
button at this point), it means that the personal password and administrative
code have been restored to their initial values of '1234' and '123456',
respectively. Additionally, all door access records have been cleared.
IX. Power and voltage indicator:
1. Power: Uses four 1.5V alkaline batteries. When the battery is fully charged, a
solid battery icon is displayed. When the battery voltage is low (below 4.80±
0.30V), an empty battery icon is displayed, and during door opening, the screen
will show 'LO-BATTE' (low battery) to indicate low voltage and remind you to
replace the batteries.
2. Operating voltage: 4.2~7.5V
3. Operating current: 320mA
4. Static current: 35µA (at 6.0V)
5. Operating temperature: 0~50 ℃
VIII. Vibration alarm function:
1. In standby mode, press the '0' key. The screen will display 'ALert on' and enter
the alert state.
2. When the alert state is active, the safe will trigger an alarm if it detects
vibration. The screen will display an alarm bell symbol and '------' to indicate
the alarm.
3. In this case, enter the correct password. The screen will display 'OPEN', the
alarm will stop, and the alert state will be lifted, allowing the safe to be
unlocked.
4. When the alert state is active, performing a single correct door-opening action
will cancel the alert state.
