ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
3
4
1.Turn On/Standby
Press this key to turn on unit or switch to standby mode. At power on, unit will automaticly turn
on and restore to previous status.
2/9.Dynamic Mode Adjust
Switch to dynamic mode from static color, or switch between dynamic modes.
3/10.Dynamic Speed Adjust
Adjust dynamic playing speed.Press SPEED+ to increase speed and press SPEED-to decrease.
Unit will switch to dynamic mode lf press this key at static color mode.
4/5.Static Color Adjust
Switch to static color mode from dynamic mode,or switch between static colors.
6.Direct Color Select
Shortcut key to static colors. When press the specific color key,LED will play the same static color.
The direct colors are included in 'COLOR+' and "COLOR-' operation.
7/8.Brightness Adjust
Adjust static color brightness. Press to increase brightness and press BRIGHT-to decrease.
Unit will switch to static color mode If press this key at dynamic mode.
11.Demo Mode
Press this key will switch to Demo mode.At demo mode,it plays 17 dynamic modes in loop,each
mode repeat 3 times.
1.Power Supply
This unit accepts DC 5V to 24V power supply. The DC xjack's inner pole (or red cable) is
positive and sleeve (or black cable)is negative. Also please make sure the power supply voltage is
same as the LED load.
2.LED Output
This unit support common anode connection LED products. The mark ' ' indicates the common
connection node.
The peak output current is 4 amperes and maximum constant current is 2 amperes per channel.
Please reduce load if main unit is overheating.
CAUTION! Do not short circuit or overload the LED outputs, this may lead to permanent damage!
Installing
Operation
1. Using Remote Controller
Please pull out the battery insulate tape before using. The RF wireless remote signal can pass
through barrier, so it's not necessary to aim at the main unit when operate.
For proper receiving remote signal, please do not install the main unit in closed metal parts.