24
6. MACHINE
’S SAFETY INFORMATION
6.1 Lifting, installation, electric maintenance of the machine should be carried out by qualified personnel only.
6.2 Routine maintenance and scheduled maintenance should be carried out by qualified personnel after unplugging the
machine first.
6.3 Ensure that the machine has been cleaned, tested and maintained before starting to operate it.
6.4
Check the safety devices, power cable and moving parts regularly. Don’t operate the machine before having replaced
defective safety devices or faulty parts.
6.5 Never replace the cutting tools before unplugging first.
6.6
Keep foreign materials away from the working area of the machine, keep away from the machine’s moving parts.
6.7 Do not work on the machine by removing the protective parts
The safety data have been defined above. In order to prevent physical damage or damage to the
equipment, please read the safety information carefully and keep the manual always in an easy
accessible place.
7. OPERATION
7.1 Preparation
7.1.1 Degrease and dry the machine table. Especially ensure that the holding grips and handles are clean and dry
7.1.2 Clean all surfaces of the machine from chip and foreign particles. Use eye glasses for protection.
7.1.3 This machine can process on products manufactured from rigid plastic and aluminum materials
that don’t
include iron alloy.
7.1.4 Control whether cutting tools (FIGURE 2 NO.28) are inserted safely to their places.
7.1.5 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
7.1.6 Cutting tool must process on the part after machine is operated and cycled.
7.1.7 Absolutely control the direction of rotattion of the saw.
7.1.8
Do not process the profile before clamping the work piece properly.
7.2 Operation
7.2.1 Move the mobile unit (FIGURE 1) roughly to the desired measure by using the meters measuring system
incorporated on the frame. Move it to the desired precise measure (+ / - 0.1) by rotating the hand wheel
(FIGURE 4, NO. 84) located on the mobile unit in rightward or leftward direction by using the read-out piece
(FIGURE 4, NO. 128) and the digital measure read-out (FIGURE 4, NO. 83) found on the measure.
Immobilize
the mobile saw head by activating the pneumatic brake system.
7.2.2
The clamps shall not clamp on and the saw head cannot be moved for safety reasons unless the brake
system on the mobile unit is activated.
7.2.3 Cutting speed setting can be adjusted independently from each other by means of the reducing valves (FIGURE
3, NO. 71) located on the mobile and fixed units.
7.2.4 Fix the profile by pressing the clamp open-close button (FIGURE 3, NO. 75/4) on the control panel (FIGURE 3,
NO. 75) after cutting length is adjusted.