YewdaleDefiant
®
Manufacturing instructions
Part no: 1002
4
Manufacturing Instructions
YewdaleDefiant
®
vertical blinds (VL31 Split Draw)
VL31 Split Draw Control:
Please note, eye, hand and ear protection must be worn when carrying out the
tasks below.
1
.
Check the profile - part number 92700W, and spline - Part number 927006,
are free from damages.
2
.
Cut profile 92700W to blind width minus 4mm .
3
.
Cut spline 927006 to blind width minus 4mm.
4
.
Insert spline into the right-hand end cap - 927015W, securing with stop ring
on the outside edge – 927010.
5
.
Using the chart below, insert the appropriate tubular spacers, part number
927007W onto the right-hand end of the spline. Should the spacers require
cutting in half, use a sharp knife.
6
.
Select the appropriate trucks:
• If left hand control and 127mm, use 927002L
• If right hand control and 127mm, use 927002R
• If left hand control and 89mm, use 927003L
• If right hand control and 89mm, use 927003R
VL31 89mm split draw
VL31 127mm split draw
Control End
Control End
1.5
2.5
