YewdaleDefiant
®
fitting instructions
Part no: 949
6
R42 Spring assisted sidewinder control:
5
.
Remove the blind and fix the pin-end bracket using appropriate screws/
plugs.
6
.
Insert the spring sidewinder end of the blind into its bracket. Turn the clear
plastic wheel at the pin-end of the blind to retract pin. Locate the blind into
the pin-end bracket and turn the wheel in the opposite direction to extend
the pin into the bracket.
7
.
Bring the blind down from its ‘up’ position using the sidewinder control
chain. Now check the blind opens by pulling on the front part of the chain.
With one touch, hold the chain down while the blind rises (intermediate
positions are achieved by letting go of the chain at the desired point). If
the fabric does not wind up completely when the blind is operated, greater
spring tension can be applied as follows:
a) Bring the blind down 250mm from its uppermost position.
b) Remove the blind from the brackets and roll the fabric by hand into
the roller.
c) Replace the blind in the brackets.
d) If tension is still not enough, repeat sets a to c.
e) If tensioned too much, follow the above but in reverse. Remove the
blind from the brackets and unroll the fabric by hand off the roller.
8
.
Ensure the blind is not over tensioned as the blind is designed to rise to the
top and slow down and stop without the bottom bar hitting the brackets,
otherwise the bottom bar can get trapped between the tube and the wall.
Fitting Instructions
YewdaleDefiant
®
roller blinds(R42)
