YewdaleDefiant
®
Manufacturing instructions
Part no: 2004
6
1
.
Ensuring the head box/fascia profile is square within the saw, cut the head
box to size.
2
.
Ensuring the head box cover is square within the saw, cut the head box to
size making sure there is no distortion.
N.B It is critical that the profile is cut square to enable the cover to close.
3
.
Cut the barrel, bottom bar, fabric, side channels and PVC insert to size.
4
.
File all aluminium cuts and cut a small V-shape in the top of the PVC tracker
profile to assist in fabric location.
5
.
Weld a pocket at the bottom of the fabric to fit the fabric insert (see
diagram on Page 4). Weld zips onto fabric both sides of the fabric to match
the drop of the blind.
6
.
Attach the fabric to the barrel making sure the narrow end of the fabric is
attached and central to the barrel.
7
.
Attach the bottom bar to the fabric using the fabric insert. Once complete
insert the end caps.
8
.
Insert the transition plates into the head box and attach the end plates
using 933010 screws.
9
.
Cut the chain to length and attach to control mechanism.
10
.
Making sure the control is on the correct side, insert the control mechanism/
pin end into the barrel and place the barrel and fabric into the head box.
11
.
Using the punch provided, punch a hole in the head box cover to enable the
chain to enter/exit the head box:
a) Place the
template on the
control side of head
box cover and mark
the hole for the
chain guide using
a pencil (template
should be pushed
firmly against the lip
on the cover).
C40-60T Cassetted Blinds:
Use this
hole on the
template
Manufacturing Instructions
YewdaleDefiant
®
cassetted blinds (C40-60T)
