Yetter AIR ADJUST 2940, Operator'S Manual

Page: 47 / 64

47
MAINTENANCE
-Perform each lubrication and service procedure at the beginning and end of each season.
-Clean grease fittings before using grease gun, to avoid injecting dirt and grit into the bearing.
-Replace any lost or broken fittings immediately. If a fitting fails to take grease, remove and clean thoroughly,
-Replace fitting if necessary. Also check for failure of adjoining parts.
BEARING REPLACEMENT INSTALLATION
1. When assembling the spoke wheels, bearing assembly and hubcap, be sure to align the grease transfer hole in the spoke
wheel with the groove in the hubcap and hole in the hub to allow grease passage.
2. Assemble the wheels, hubs and caps.
3. Grease the wheel/hub/bearing assembly.
Storing the Equipment
Store the machine in an area away from human activity
Store the machine in RAISED position.
Install service locks on all wheel cylinders.
At the end of the season, the machine should be thoroughly inspected and prepared for storage. Repair or replace any
worn or damaged components to prevent down time at the start of the next season. Store the machine under cover with all
parts in operating condition.

Clean machine thoroughly to remove all dirt, debris, and crop residue, which would hold moisture and cause rusting.

Inspect machine for worn or broken parts. See your Yetter Farm Equipment dealer during the off-season so that parts or
service can be acquired when machine is not needed in the field.

Lubricate bearings as outlined in the Lubrication section.

Paint all parts which are chipped or worn and require repainting.

Store machine in a clean, dry place with the planting unit out of the sun.

If the machine cannot be stored inside, cover with a waterproof tarpaulin and tie securely in place.

Do not allow children to play on or around the machine.
AIR BAG REPLACEMENT
2940-386
6” AIR BAG
2940-388
8” AIR BAG