Yetter 5500 Series, Owner'S Manual, Part Identification

Page: 8 / 16

8
ASSEMBLY INSTRUCTIONS
Step 4: Install the Devastator roller, spacer and bearings to the roller tube using the
½” x 2-1/2” bolts and locknuts.
IMPORTANT: The spacer must be installed between the roller and the bearing.
The notches of the bearing housing must face the mounting plate. The
extended race on the bearing will face toward from the roller.
BEARING REPLACEMENT
Put the bearing housing in a vice, use a pry bar to turn the bearing in the housing parallel with the slots, remove the old
bearing, apply anti-seize lubricant to the interior of the bearing housing, insert the new bearing in the slots, & use a pry bar to
move back to position. Wobble the bearing around to help work the lubricant into the outer race of the bearing.
NOTE: AFTER FASTENING THE MOUNTING
HARDWARE FOR THE BEARINGS, SPIN
EACH ROLLER BY HAND TO MAKE SURE
EACH ROLLER SPINS FREELY.