Yetter 2968-020B, Set-Up / Parts Manual

Page: 20 / 48

20
INSTALLATION INSTRUCTIONS
STEP 8B: REAR KNIFE INSTALLATION
Assemble the 3/8 Hose P Clip to the horizontally slotted hole by placing the P Clip over the bolt threads, insert the 3/8” bolt thru
the slotted hole, place a 3/8” flat washer & 3/8” lock washer over the bolt, & install a 3/8 hex nut. Insert 1) 3/8” X 3” bolt thru
the stop bushing & insert the bolt thru 1 of the rear set of vertical holes that matches the blade. (If blade is in the 2
nd
hole from
the bottom, the stop bolt/bushing needs to be in the 2
nd
hole from bottom) Place a 3/8” flat washer & lock washer over the bolt
on the outside of the mount plate & hand tighten the 3/8” nut. Insert the hook on the spring onto the notch on the knife & place
the stepped bushing thru the spring. Place 1) 3/8” flat washer over the remaining 3/8” X 3” bolt, insert bolt thru knife/stepped
bushing, & insert bolt thru 1 of the front set of vertical holes that match the stop bolt/bushing. Make sure the spring wire stop is
on the bottom side of the stop bushing. Once the bolt is in position, place a 3/8” flat washer & lock washer over the bolt & hand
tighten the 3/8” nut. Make sure the stepped bushing goes thru the knife & then tighten all the hardware down from this step.
LH KNIFE ASSEMBLY RH KNIFE ASSEMBLY
MAKE SURE THE
SPRING ROD IS ON
THE BOTTOM SIDE
OF THE SPRING
STOP!