01.
With a 5mm allen wrench, remove the main
pivot Collet Wedge Bolt
02.
With a 10mm allen wrench, remove the Main
Pivot Collet Axle. The Collet Nut on the drive
side can remain in the frame.
03.
Rotate your swingarm upwards to access
both grease zerks and expose the whole
Switch Infinity link. With a clean rag and
mild detergent, clean any mud, dust, or
debris off the Switch Infinity Link.
04.
Using a needle-type grease gun, push new
grease into the two Switch Infinity grease
ports until you see grease extruding from
the shaft seals.
05.
Wipe off any excess grease that was
pushed out of the seals.
06.
Lower the swingarm and re-install your Main
Pivot Collet Bolt
Torque 3.5 Nm
07.
Install the Main Pivot Collet Wedge and
torque to 14 Nm.
48*5$)*/'*/*5:
4&37*$&
.
Summary of Contents for SB130
Page 1: ...08 3 4 6 5 4...