Operating Instructions IQ WAXER NT light
7. Handpiece-wire is non-flammable and more stable to temperature. Nevertheless avoid contact with hot
modelling tip or open flame (Bunsen burner !).
8. If wire is damaged stop usage immediately and send in for repair.
9. Unit only to be opened by skilled personnel. Any misuse of the unit willl lead to
loss of warranty and
liability.
10. Pull out the plug before opening the unit !
11. Do not pull the plug out of the socket by means of the wire.
12. Do not use any solvents for cleaning of the unit.
13. Ensure safe packaging when returning a unit (e.g. for repair)
4.
Operating instructions:
4.1.
Before putting into operation:
Our Waxer follow the latest technical developments and the standard regulations of safety.
Nevertheless
dangerous situations may occur.
♦
Usage of the unit only in perfect conditions and according to operating instructions !
♦
Observe applicable regulations for save work. Usage by skilled personnel only.
♦
Unit to be checked for perfect technical condition, wires included !
♦
Turn the required modelling tip onto the heating element of the handpiece.
♦
Lay down handpiece on a safe place (Art. No. 410-0000 is not appropriate). If foot pedal is used connect
pedal switch into unit back.
♦
Put the plug into the socket (adapt only to licensed sockets - observe type registration)
♦
The Waxer does contain a special programm which through it, deffected tips can be detected and
prevented from booting the unit.
4.2 Function:
Switch on the unit at the back. The LED optical sensor lights on 2 times in orange when switching on the
unit and lights afterwards green. The unit is under “Touch Control” and heats up in seconds by touching the
metal ring. For optical control of the heating the color of the optical sensor LED changes to orange until the
contact with the metal ring is interrupted. The unit stops heating and cools down to room temperature. The
optical sensor lights green again. The Touch Control function can be released by finger touch of the metal
ring on the handpiece or optional by using the pedal. The connector for the pedal is on the back of the unit.
If you prefer the “Continous” modus just press the button (C) under the light sensor. The color of the LED
changes to orange and works in “Continous”. By pressing again the button the unit changes again to the
Touch Control function and the LED color changes to green.
The temperature of the unit can be controlled with the regulator for both functions. We recomed to reduce
the temperature on the continous mode.
Attention:
We recomend to read the instructions of use. In case you have lost the instructions please
download it under: www.yeti-dental.com .
4.3
Adjusting the ring of the handpiece
