Yenista Optics OSICS, User Manual

Page: 58 / 252

Using the OSICS BKR Module
58 OSICS User Manual
BKR
TL
S-50
AT
N
DFB
EC
L
T100
SLD
SW
T
TLS-A
G
SW
T A
PC
MAI
N
7.1.2 OSICS BKR Module Overview
Figure 30: OSICS BKR Module – Front and Rear Panels
Front Panel Optical Connectors
The fiber optic connector is standard input/output FC/APC type connectors (narrow key).
For more details on the appropriate fiber type and laser power compatibility, see section
OSICS BKR Technical Specifications, p. 57 .
The label located on the optical output connector cap indicates the location of the
laser source.
Retaining Screw
The captive screw enables you to lock/unlock the module inserted into the slot of the
OSICS Mainframe.
Rear Panel Notches
The top and bottom notches enable you to slide the module into the OSICS Mainframe
slot (see section Installing an OSICS Module Into the OSICS Mainframe, p. 23 ).
Opening
for air output
Top Notch
Bottom Notch
96-pin VME
Connector
Retaining Screw
Input/Output Optical
Connector
FC/APC type
The use of optical instruments with this product increases eye hazard.
Do not look directly into the fiber end of an optical cable connected to
any optical output while the device is in use. This may cause permanent
eye damage.
The OSICS Mainframe does not support "hot-swap" of modules; for more
details, see section Handling OSICS Modules Into the OSICS Mainframe,
p. 23 ).
WARNING
CAUTION