Yellowtec m!ka Mic Arm, Briefing Book

Page: 24 / 27

46 47
Page 19
- To prevent slip, attach the self-adhesive rubber pad to the upper inside of the clamp.
- (1) Bolt the m!ka System Pole to the clamp by using the size 5 Allen Key.
- (2) Then use the size 6 Allen Key to secure a proper fit to your table.
- The m!ka Pole Table Clamp is suitable for a panel thickness of 14-40mm.
Page 20
- When installing the m!ka System Pole Ceiling Mounting Kit it is your obligation to
verify that your ceiling and your fasteners are suitable to hold the load.
Page 21
- To secure a minimum vertical position of your monitor insert the Safety Stop nut into
the m!ka Pole. Use an Allen Key and fasten it properly.
Page 22
- Make sure you have checked the max. payload of your m!ka Monitor Arm. The
information is printed on the product label on the rear side of its QuickFix.
- See Page 21 for how to secure a minimum headroom under your monitor.
Page 23
- In order to prevent unintended changes to the height position, simply remove the
thumbscrews by pulling them out. Before you remove the screws, make sure they are
all properly tightened.
Page 24
- Use an Allen Key to adjust EasyLift‘s pneumatic spring to your monitor‘s weight.
- Use the knurled screws at the rotating joints to adjust the retardation of the joints.
m!ka Remarks
Page 25
- You can deactivate the QuickFix function for security reasons. Turn in the screw next
to the release lever in order to disengage its function.
Page 26
- The m!ka QuickFix adapter is suitable to be used with VESA 75 and VESA 100.
- Make sure that you use the correct screw size and length. Too long screws will
damage your flat panel!
Page 27
- You can deactivate the QuickFix function for security reasons. Turn in the screw next
to the release lever in order to disengage its function.
Page 28
- Use the knurled screws to de- or increase the retardation of your m!ka Monitor Arm‘s
joints.
Page 29
- (1) Insert the cable organizer clip into the bottom profile of the m!ka Monitor Arm.
- (2) Then turn it 90° to fix it.
Page 30
- Use the m!ka Pivot Monitor Adapter to rotate your monitor up to 90° clockwise or
90° anti-clockwise. Within this range the adapter is infinitely adjustable.
- Only use the attached screws to fix the m!ka Pivot Monitor Adapter to your m!ka
Monitor Arm.
- Mounting is possible via VESA 100 mount only!
- With m!ka Pivot Monitor Adapter installed you cannot use QuickFix.
- (1) Use the 4 hex screws to mount the adapter to your monitor via VESA 100.
- (2) Use the 4 cross screws to attach the adapter to a m!ka Mic Arm via VESA 100.