Section 3. Troubleshooting
Section 4. Reference
Control Menu
DMX Protocol
Specification
Control Menu
MENU1:
Dmx:15CH
(PRESS ENTER)
Dmx:15CH
Add:xxx
DMX512: Press UP/DOWN to set up 1-512 add value,
always remember press ENTER to save your
settings.
Test
Auto
AUTO: Press ENTER to active auto running and to
save the settings.
MENU2:
Test
(PRESS ENTER)
Test
Sound
SOUND: Press ENTER to active auto running and
to save the settings.
MENU3:
Manual
(PRESS ENTER)
Manual
CH01
：
xxx
…
Manual
CH15 :xxx
Manual: UP/ DOWN adjust value 0-255, press
ENTER to save. (CH01-CH15 stands for 15
channels, same function as DMX console.)
Option
Pan:Yes
X/Pan
clockwise
and
anti-clockwise
setting:
UP/DOWN to choose Yes/No, press ENTER to
choose and save. Choose Yes is X anti-clockwise
running.
MENU4:
Option
(PRESS ENTER)
Option
Tilt:Yes
Y/Tilt clockwise and anti-clockwise setting: UP/DOWN
to choose Yes/No, press ENTER to choose and save.
Choose Yes is Y anti-clockwise running.
Probable cause(s)
Remedy
No power to fixture
Check power cables
Primary fuse blown
Replace fuse
No response from
fixture when power
is applies
Secondary
fuse
blown
Replace fuse
Controller
not
connected
Connect controller
Incorrect
addressing of the
fixtures
Check address setting on fixture and controller
Bad
data
link
connection
Inspect cables and correct poor connections
and/or broken cables.
Conflict
between
tracking and vector
control
Eliminate scene cross-fade on controller
Data
link
not
terminated
Insert termination plug in output of last fixture
Fixture resets but
does not respond
correctly
to
controller(DMX
mode operation)
Defective fixture or
2
devices
transmitting on link
Bypass fixtures one at a time until normal
operation is regained:unplug both connectors and
connect them directly together
Colors cannot be
mixed
Random
color
mixing is on
Turn off random color mixing
Fixture does not
reset correctly
Electronic
or
mechanical failure
Contact service technician
Lamp missing or
blown
Disconnect fixture and replace lamp
No light, lamp cuts
out intermittently,or
burns out too
quickly
Fixture or lamp is
too hot
Allow fixture to cool. If problem persists,contact
service technician
