Controlling Board
1
2
3
4
5
6
1. Display
Display menu and selected function.
Button
MENU
switch menu function
UP
On function: page up
On numerical value: increase value
DOWN
On function: page down
On numerical value: reduce value
ENTER
Settle selected function and value
3. DMX signal input
Control model by DMX signal
，
please use 3pin
/5pin
XLR signal cable.
4. DMX Signal output
Transfer DMX signal to next model, please use 3pin
/5pin
XLR signal cable.
5. Power output
Connect to obtain power
, Neutric power connector is optional
(attention
：
please use connect to stated voltage.)
6
．
Power input
Connect to obtain power, Neutric power connector is optional
Machine Connection
Cable Connectors
Cables must have a male XLR connector on one end and a female XLR connector on the
other end.
A word on termination: DMX is a resilient communication protocol,
however errors still occasionally occur. Termination reduces signal errors, and therefore best
practices include use of a terminator in all circumstances. If you are experiencing problems
with erratic fixture behavior, especially over long signal cable runs, a terminator may help
improve performance.
To build your own DMX Terminator: Obtain a 120-ohm, 1/4-watt
resistor, and wire it between pins 2&3 of the last fixture. They are also readily available from
specialty retailers
.
Master-Slave control model
：
Set up one fixture as Master fixture(triggering),other fixtures as slave
fixtures(receiving trigger signals).Set up all fixtures
same
address value or
following DMX controller performance(Attention: all fixtures use the same DMX
channel-7 or 11CH)
Maximum 8 PCS fixtures connected by Daisy chain connection.
