yeep.me 100, Manual, Page: 12 / 22

14
EN
Folding
1.
Place the device in front of you in a horizontal position.
2.
If the device is equipped with folding handles, fold them away to the sides
if needed.
3. Unlock the device by lowering the lever (9) .
4. Push the folding lever (14) .
5. Lower the scooter frame by 90 degrees.
6.
The process is complete.
3.4. CHARGING AND BATTERY INDICATOR
Charge the battery before first use. To do so, charge the device using the
charger
supplied
.
WARNING:
All charging operations must be performed with the original charger
(charger part number listed in the “CONTENTS AND TECHNICAL DATA” section)
supplied with the unit.
The external flexible cable of this transformer cannot be replaced; if the cable is
damaged, the transformer must be disposed of.
If in doubt, lost or malfunctioning, do not charge the unit with another charger. A new
one should be obtained from your dealer. You will find the email of the support to
contact on the last page of the warranty manual.
Next, check the battery charge level before use, using the battery level
indicator
(20).
Notice: We recommend you fully recharge the battery after each use and at
least once a month.
WARNING: The device must be unfolded and on its stand for charging to avoid
damaging the charging plug.
1. Remove the charging port cover and ensure there is no water or any other
liquid inside the charging connector, and that it is free of any objects that
could cause a short circuit or prevent the plug from being properly and safely
plugged in. Then, connect one end of the charging cable to the charging port
(13) BEFORE connecting the other end to a power source. BEFORE connecting
the plug to the mains, ensure that the charger is first connected to the device
correctly by referring to the codes on the device.
2.
The charger indicator will light up red when charging.
3 . The charger indicator will light up green once charging is complete.
4. When charging is complete, disconnect the mains plug from the outlet first,
then unplug the charger from the device. Finally, close the cover to prevent