Yealink W60P Telesystem, Administrator'S Manual

Page: 183 / 264

Administrator’s Guide for W60P/W53P/W41P DECT Phones
176
Parameter voice.jib.adaptive <y0000000000xx>.cfg
Description It configures the type of jitter buffer in the wired network.
Permitted
Values
0 -Fixed
1 -Adaptive
Default 1
Web UI Settings->Voice->JITTER BUFFER->Type
Parameter voice.jib.min <y0000000000xx>.cfg
Description
It configures the minimum delay time (in milliseconds) of jitter buffer in the wired network.
Note : It works only if “voice.jib.adaptive” is set to 1 (Adaptive). The value of this parameter should be less
than “voice.jib.max” and “voice.jib.normal”.
Permitted
Values
Integer from 0 to 400
Default 60
Web UI Settings->Voice->JITTER BUFFER->Min Delay
Parameter voice.jib.max <y0000000000xx>.cfg
Description
It configures the maximum delay time (in milliseconds) of jitter buffer in the wired network.
Note : It works only if “voice.jib.adaptive” is set to 1 (Adaptive). The value of this parameter should be
greater than “voice.jib.normal” and “voice.jib.min”.
Permitted
Values
Integer from 0 to 400
Default 240
Web UI Settings->Voice->JITTER BUFFER->Max Delay
Parameter voice.jib.normal <y0000000000xx>.cfg
Description
It configures the normal delay time (in milliseconds) of jitter buffer in the wired network.
Note : It works only if “voice.jib.adaptive” is set to 0 (Fixed). The value of this parameter should be greater
than “voice.jib.min” and less than “voice.jib.max”.
Permitted
Values
Integer from 0 to 400
Default 120
Web UI Settings->Voice->JITTER BUFFER->Normal
DTMF
DTMF (Dual Tone Multi-frequency) tone, better known as touch tone. DTMF is the signal sent from the IP phone to the
network, which is generated when pressing the IP phone’s keypad during a call. Each key pressed on the IP phone gen-
erates one sinusoidal tone of two frequencies. One is generated from a high-frequency group and the other from a
low-frequency group.
Topics
DTMF Keypad