BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W60B IP DECT PHONE
20-BD5561-00
©
2018 BROADSOFT INC.
PAGE 18 OF 117
4 W60B IP DECT PHONE Configuration
This section describes the configuration settings required for the W60B IP DECT PHONE
integration with BroadWorks, primarily focusing on the SIP interface configuration. The
W60B IP DECT PHONE configuration settings identified in this section have been derived
and verified through interoperability testing with BroadWorks. For configuration details not
covered in this section, see the
Yealink W60B IP DECT PHONE User Guide
4.1 Configuration Method
The capabilities of the
W60B IP DECT PHONE
have been verified for use with
BroadWorks based on the settings described in the following table. For more information
on the meaning, purpose, and applicability of the individual configuration items see the
Yealink
W60B IP DECT PHONE
User Guide
Configuration Files
Files Provided by Partner
Level
Description
y0000000000<xx>.cfg
system configuration file
“y0000000000xx.cfg”, where “xx”
is associated with the hardware
version of Yealink Device.
<MACADDRESS>.cfg
device-specific
configuration file
Device specific account
information file.
4.2 System Level Configuration
This section describes system-wide configuration items that are generally required for
each
W60B IP DECT PHONE
to work with BroadWorks. Subscriber-specific settings are
described in the next section.
Step
Command
Purpose
System Configuration Items y0000000000<xx>.cfg
Step 1
Set SIP Proxy/Domain.
account.1.sip_server_host =
as.broadworks.net
account.1.SIPServerPort = 5060
account.1.sip_server_type = 2
Set the W60B IP DECT PHONE SIP
server to the Fully Qualified Domain
Name (FQDN) for the BroadWorks
Application Server cluster.
The domain must match the domain
configured for the BroadWorks
subscriber’s line/port domain.
Set the SIP server type of W60B:
Default=0
BroadSoft=2
Step 2
Set Outbound Proxy.
account.1.outbound_proxy_enable =
1
account.1.outbound_host =
sbc.broadworks.net
account.1.outbound_port = 5060
Set the Outbound Proxy to the
session border controller (SBC) if one
is deployed between the W60B IP
DECT PHONE and BroadWorks.
If there are redundant SBCs, set it to
the FQDN for the SBC cluster.
Step 3
Set SIP Timers.
sip.timer_t1 = 0.5
sip.timer_t2 = 4
sip.timer_t4 = 5
The SIP timers should be set to levels
short enough to support a timely
failover when there is no server
response.