5
Configure a Static IP
The following introduces how to use the remote control to configure a static IPv4 address:
1. Select
More
->
Setting
->
Network
->
Wired Network
(Default Admin Password:0000).
2. Select
IPv4
from the pull-down list of
IP Mode
.
3. Select
IPv4
, and then press OK key.
4. Disable
DHCP
.
5. Enter the IP address, subnet mask, gateway and DNS information in corresponding fields.
6. Save the change
.
The screen prompts “
Reboot now?
”.
7. Select
OK
to reboot the
endpoint
.
Configure Port Mapping
If you deploy the endpoint in an Intranet, you must forward the following ports to the public network on
the firewall, so that your endpoint can receive a public-to-private call.
Port
Function
H.323 signal port
SIP
optional
Audio & Video media stream port
Web management port
optional
Protocol Type
UDP/TCP
5060-5061
443
50000-51000
1719-1720
TCP/UDP
TCP/UDP
TCP
When you use intelligent traversal to deploy your endpoint, you have to open following ports on
your firewall if they are restricted.
It is recommended that you forward the web management port(443/TCP) to the public network,
so that other office can remotely manage the office.
Port
Function
H.323 signal port
SIP
optional
Audio & Video media stream port
Protocol Type
UDP/TCP
TCP/UDP
TCP/UDP
50000-51000
5060-5061
1719-1720
Do one of the following to deploy the endpoint:
Option1
: Assign a static public IP address to your endpoint.
Option2
: If you deploy the endpoint in an Intranet (behind the firewall), assign a static private IP
address to it and do port mapping on the firewall.
Option3
: Deploy the endpoint using intelligent traversal. You only need to assign a private IP
address to your endpoint. Make sure this private IP address can access the public network.
Only outbound calls are available when using this method.
Traditional Deployment
