You will then need to program the headset to tell it which ehs you are using.
If you have a
Jabra Pro 920 or Pro 925
follow these instructions.
Put on the headset, and simultaneously press and hold both volume buttons (+) and (-) on the top of the headset
until the Voice prompt says “Set up” then release the buttons.
Press the black multifunction button on the side of the headset and cycle through the settings until you hear
“Remote Call Control”
Then press the (+) button until you hear “DHSG”Then press and hold both volume buttons again until the voice
prompt says “Goodbye”
The base will restart and apply the new settings
If you have a
Jabra Pro 9450
follow these instructions.
1.
Ensure there are no active calls.
2.
Remove the front panel of the Jabra PRO 9450 base.
3.
Center-press (push it directly in rather than side to side) the microphone volume switch on the
base to enter setup mode. The mute indicator will blink slowly to indicate setup mode.
4.
Tap the desk phone button on the keypad to cycle through the settings. The first setting is Remote
call control (the phone symbol on the base should be solid white to indicate remote call control
mode)
5.
Tap the softphone (computer) button on the keypad to cycle through the values for each setting.
For DHSG mode the computer light on the headset base needs to be a
FLASHING
green.
6.
When finished, center-press the microphone volume switch to save settings and exit setup mode.
The base will restart.
