Passion PH150 Phono Amplifier
Page 8
www.ybahifi.com
MM/MC
PH
150
Phono MC
Phono MC
MM
MC
RCA
XLR
R
L
ANALOG OUTPUT
INPUT
Designed in France
V
Hz
W
N
160
PHONO AMPLIFIER
PASSION PH
150
HIGH MC
Discovering your PH150: Front view
2
3
1
2
1
1
Discovering your PH150: Back view
2
3
1
2
2
3
1
2
7
6
3
4
1
5
3
4
5
7
6
Power inlet: Connect provided mains cable. Be sure your PH150 switch is in OFF position before
plugging or unplugging the mains cable.
Balanced Audio output: This is a higher quality output that can reject noise and interference in the
cable when used with equipment with balanced inputs. XLR connectors should be wired as follows:
Pin 1 - Ground; Pin 2 - Hot (in-phase); Pin 3 - Cold (phase-inverted).
RCA output: Connect the RCA outputs of your PH150 to the RCA inputs of your pre-amplifier.... (for
example Passion PRE5 0)
5
2
3
2
ON/OFF switch: Use this button to switch ON or switch OFF your PH150.
1
DISPLAY
and IR sensor: Any information concerning your PH150 will be indicated here.
Input selector: To selector between different cartridge types - MM or MC.
Ground. This is a terminal that allows the tone arm shield cable to connect directly to the chassis of
the PH150 to eliminate any radio interference or hum from the signal.
M
C
input: nput impedance 3-100ohm, 60dB Gain
oving oil (MC)
I
High
MC input: nput impedance 47Kohm, 45dB Gain
output Moving Coil (
)
I
Moving Magnet (
)
I
MM input: nput impedance 47Kohm, 40dB Gain