YATO YT-82836, Manual

Page: 16 / 128

16
GB
O R I G I N A L I N S T R U C T I O N S
SPECIFICATION OF THE PRODUCT
Pole pruner is a type of chain saw, used to care for tree crowns. It allows to cut small branches in places inaccessible to traditional
pole pruners. Because its operation is much quieter than in the case of combustion tool, its operation is also possible in vicinity
of buildings. Due to the battery power supply, the pole pruner allows you to work in areas, which are not accessible for to mains-
powered products. Correct, reliable, and safe operation of the device is dependent on its proper use, therefore:
Prior to working with the tool, you should read all the instruction and keep it around.
For any damages or injuries caused by the tool misuse, resulting from failure to comply with its designation, non compliance with
with safety regulations and recommendations included in this manual, the supplier does not accept any liability. The tool misuse
causes also the loss of user’s rights to the guarantee and warranty.
EQUIPMENT OF THE PRODUCT
The product is supplied in a complete state but before the fi rst use it is required to assembly it.
With the pole pruner there are supplied: cutting chain, guide shield, battery, the charging station and belt carrier.
Attention! The product of the catalog number: YT-82837 has not been equipped with a rechargeable battery and charging sta-
tion.
TECHNICAL DATA
Parameter Unit Value
Catalog number YT-82836, YT-82837
Rated voltage [V] 18 DC
Speed of the chain travel [m/s] 5
Rotational speed [min
-1
] 2500 ± 10%
The length of guide bar [mm /’’] 200 / 8
The length of cutting [mm] 165
Chain scale [mm] 9.525
Chain spread [mm] 19
Chain type 91P033
Type of the chain guide M1430833-1041TL
Number of teeth of the chain drive wheel and scale 6 teeth x 9.525 mm
Electric protection class III
Oil tank capacity [cm 3 ] 60
Weight (without the battery, guide and chain) [kg] 3.25
Noise level
- L
pA
(pressure) [dB (A)] 78.2 ± 3.0
- L
wA
(power) [dB (A)] 91.2 ± 2.36
Vibration (rear handle/front handle) [m/s 2 ] 2.109 ± 1.5
Type of the battery Li-Ion
Capacity of the battery* [Ah] 2
Energy of the battery* [Wh] 36
Charging station*
Input voltage
[V~] 220 - 240
Mains frequency [Hz] 50 / 60
Rated power [W] 60
Output voltage [V] 21 DC
Input current [A] 2.4
Time of charging** [h] 1
* only for models equipped with battery and charger
* * charging time applies only to the battery with a capacity listed in table
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.