TREATMENT METHODS
1. make-up removal
Before performing the procedure, carefully clean the skin from
external impurities and excess sebum.
2. Preparing for surgery
Must be applied at the discretion of one of the featured pre aratów
to surgery (see table p. 7) or a cotton swab included.
3. Turn on the device and setting the Parametro
After switching on, select a treatment program and intensity.
IMPORTANT! The intensity should be selected individually from
the lowest to the feelings.
4. Performing surgery
Programs: CLEAN MOISTURE, RF LED
-
Put your head gently to the skin. The print
head should be in full contact with the skin.
-
Move the head along the face muscles from
inside to outside with a continuous motion at
a rate of about 2 cm / second.
-
If you felt the heat is too intense need to
accelerate
the
movement
of
the
head.
Remember not to hold the head in one place, to
avoid burns.
IMPORTANT! Do not use the eye. To perform the surgery on the eye,
it is advisable to use a low level of intensity due to sensitive skin.
page 17